Operation of Permanent Magnet Synchronous Motor after Open-circuit Battery Supply Fault

Vanja Ambrožič, Mitja Breznik, Mitja Nemec

Abstract


This paper presents a method for post-fault operation with reduced performance of a permanent magnet synchronous motor following a battery supply open circuit fault. The approach upgrades the previously developed fast model-oriented supply fault detection algorithm based on comparing actual and estimated values of a DC-link voltage. The latter is determined by the model of supply circuit and observer of battery open-circuit voltage. Implementing a post-fault concept does not require additional hardware, as it uses quantities from an already existent vector control algorithm. After the fault is detected, the algorithm is upgraded by a DC-link voltage cascade control loop.  An analytical approach to parametrization of the controller, based on the linearization and the reduction of the system's transfer function, is also proposed. Simulations and experimental results have validated the performance of the post-fault algorithm.

Keywords


power supply fault; model-based detection algorithm; control loop parametrization; DC-link voltage regulator; fault-tolerant design

Full Text:

PDF

References


D. Cabezuelo, E. Ibarra, E. Planas, I. Kortabarria, and J. I. Garate, 'Rare-Earth Free EV and HEV Motor Drives: State of the Art', in PCIM Europe 2018; International Exhibition and Conference for Power Electronics, Intelligent Motion, Renewable Energy and Energy Management, Jun. 2018, pp. 1–8.

D. Wanner, Controlling over-actuated road vehi-cles during failure conditions. Stockholm: Engi-neering Sciences, KTH Royal Institute of Tech-nology, 2015. Accessed: Sep. 29, 2018. [Online]. Available: http://urn.kb.se/resolve?urn=urn:nbn:se:kth:diva-166819

J. Zheng, Z. Wang, D. Wang, Y. Li, and M. Li, 'Review of fault diagnosis of PMSM drive system in electric vehicles', in 2017 36th Chinese Control Conference (CCC), Jul. 2017, pp. 7426–7432. doi: 10.23919/ChiCC.2017.8028529.

Y. Da, X. Shi, and M. Krishnamurthy, 'Health monitoring, fault diagnosis and failure prognosis techniques for Brushless Permanent Magnet Machines', in 2011 IEEE Vehicle Power and Pro-pulsion Conference, Sep. 2011, pp. 1–7. doi: 10.1109/VPPC.2011.6043248.

A. M. El-Refaie, 'Fault-tolerant permanent mag-net machines: a review', IET Electr. Power Appl., vol. 5, no. 1, pp. 59–74, Jan. 2011, doi: 10.1049/iet-epa.2009.0117.

T. A. Najafabadi, F. R. Salmasi, and P. Jabehdar-Maralani, 'Detection and Isolation of Speed-, DC-Link Voltage-, and Current-Sensor Faults Based on an Adaptive Observer in Induction-Motor Drives', IEEE Trans. Ind. Electron., vol. 58, no. 5, pp. 1662–1672, May 2011, doi: 10.1109/TIE.2010.2055775.

J. O. Estima, N. M. A. Freire, and A. J. M. Cardo-so, 'Recent advances in fault diagnosis by Park's vector approach', in 2013 IEEE Workshop on Elec-trical Machines Design, Control and Diagnosis (WEMDCD), Mar. 2013, pp. 279–288. doi: 10.1109/WEMDCD.2013.6525187.

W. Zhang, D. Xu, P. N. Enjeti, H. Li, J. T. Hawke, and H. S. Krishnamoorthy, 'Survey on Fault-Tolerant Techniques for Power Electronic Con-verters', IEEE Trans. Power Electron., vol. 29, no. 12, pp. 6319–6331, Dec. 2014, doi: 10.1109/TPEL.2014.2304561.

L. Mathe, C. Kopacz, L. Bede, and P. O. Rasmus-sen, 'Sensor-fault tolerant control of PMSM in flux-weakening operation using LKF observer', in Railway and Ship Propulsion 2012 Electrical Systems for Aircraft, Oct. 2012, pp. 1–6. doi: 10.1109/ESARS.2012.6387427.

S. K. E. Khil, I. Jlassi, J. O. Estima, N. Mrabet-Bellaaj, and A. J. M. Cardoso, 'Detection and iso-lation of open-switch and current sensor faults in PMSM drives, through stator current analysis', in 2017 IEEE 11th International Symposium on Diagnostics for Electrical Machines, Power Elec-tronics and Drives (SDEMPED), Aug. 2017, pp. 373–379. doi: 10.1109/DEMPED.2017.8062382.

J. Fang, W. Li, H. Li, and X. Xu, 'Online Inverter Fault Diagnosis of Buck-Converter BLDC Motor Combinations', IEEE Trans. Power Electron., vol. 30, no. 5, pp. 2674–2688, May 2015, doi: 10.1109/TPEL.2014.2330420.

H. Al-Sheikh, O. Bennouna, G. Hoblos, and N. Moubayed, 'Modeling, design and fault analysis of bidirectional DC-DC converter for hybrid elec-tric vehicles', in 2014 IEEE 23rd International Symposium on Industrial Electronics (ISIE), Jun. 2014, pp. 1689–1695. doi: 10.1109/ISIE.2014.6864869.

Y. Cai, L. Lu, P. Shen, X. Feng, H. Wang, and M. Ouyang, 'Online Weld Breakage Diagnosis for the Battery of Electric Vehicle: A Data-Driven Approach', in 2016 IEEE Vehicle Power and Pro-pulsion Conference (VPPC), Oct. 2016, pp. 1–5. doi: 10.1109/VPPC.2016.7791739.

C. Wu, C. Zhu, Y. Ge, and Y. Zhao, 'A review on fault mechanism and diagnosis approach for Li-ion batteries', J. Nanomater., vol. 2015, pp. 1–9, 2015.

United Nations Economic Commission for Eu-rope (United Nations Economic and Social Coun-cil), 'Regulation No 94 — Uniform provisions concerning the approval of vehicles with regard to the protection of the occupants in the event of a frontal collision'. Sep. 20, 2012.

Z. Ke, J. Zhang, and M. W. Degner, 'DC Bus Ca-pacitor Discharge of Permanent-Magnet Syn-chronous Machine Drive Systems for Hybrid Electric Vehicles', IEEE Trans. Ind. Appl., vol. 53, no. 2, pp. 1399–1405, Mar. 2017, doi: 10.1109/TIA.2016.2636279.

V. R. Jevremović and B. Jeftenić, 'An Efficient Braking Algorithm for Interior Permanent Mag-net Synchronous Motors', Nov. 2005.

S. M. Yang and J. Y. Chen, 'Controlled Dynamic Braking for Switched Reluctance Motor Drives With a Rectifier Front End', IEEE Trans. Ind. Elec-tron., vol. 60, no. 11, pp. 4913–4919, Nov. 2013, doi: 10.1109/TIE.2012.2233696.

Y. Wang and R. D. Lorenz, 'Creative usage of stator flux linkage to fast brake electric vehicles', in 2016 IEEE Transportation Electrification Con-ference and Expo (ITEC), Jun. 2016, pp. 1–6. doi: 10.1109/ITEC.2016.7520278.

G. D. Marques and M. F. Iacchetti, 'Sensorless Frequency and Voltage Control in the Stand-Alone DFIG-DC System', IEEE Trans. Ind. Elec-tron., vol. 64, no. 3, pp. 1949–1957, Mar. 2017, doi: 10.1109/TIE.2016.2624262.

T. Guo, J. Liu, S. Vazquez, L. Wu, H. Gao, and L. G. Franquelo, 'Predictive direct power control for grid-connected power converters with an Ex-tended State Observer based dc-link voltage regulator', in 2016 IEEE 25th International Sym-posium on Industrial Electronics (ISIE), Jun. 2016, pp. 1218–1223. doi: 10.1109/ISIE.2016.7745068.

B. K. Bose and P. M. Szczesny, 'A microcomput-er-based control and simulation of an advanced IPM synchronous machine drive system for elec-tric vehicle propulsion', IEEE Trans. Ind. Elec-tron., vol. 35, no. 4, pp. 547–559, Nov. 1988, doi: 10.1109/41.9178.

M. Breznik, V. Ambrožič, and M. Nemec, 'Detec-tion of open circuit fault in battery power supply feeding permanent magnet synchronous motor', IET Power Electron., vol. 11, no. 14, pp. 2377–2384, 2018, doi: 10.1049/iet-pel.2018.5214.

H. A. Aebischer and B. Aebischer, 'Improved formulae for the inductance of straight wires', Adv. Electromagn., vol. 3, no. 1, pp. 31–43, 2014.

S. K. Kommuri, M. Defoort, H. R. Karimi, and K. C. Veluvolu, 'A Robust Observer-Based Sensor Fault-Tolerant Control for PMSM in Electric Ve-hicles', IEEE Trans. Ind. Electron., vol. 63, no. 12, pp. 7671–7681, Dec. 2016, doi: 10.1109/TIE.2016.2590993.

C.-H. Park, D.-Y. Kim, H.-B. Yeom, Y.-D. Son, and J.-M. Kim, 'A Current Reconstruction Strat-egy Following the Operation Area in a 1-Shunt Inverter System', Energies, vol. 12, no. 8, p. 1423, Jan. 2019, doi: 10.3390/en12081423.

S. Skogestad, 'Simple analytic rules for model reduction and PID controller tuning', J. Process Control, vol. 13, no. 4, pp. 291–309, Jun. 2003, doi: 10.1016/S0959-1524(02)00062-8.




DOI: https://doi.org/10.33180/InfMIDEM2022.103

Refbacks

  • There are currently no refbacks.


Copyright (c) 2022 Vanja Ambrožič, Mitja Breznik, Mitja Nemec

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.