Voltage Mode Electronically Tunable Full-wave Rectifier
Abstract
The paper presents a new realization of bipolar full-wave rectifier of input sinusoidal signals, employing one MO-CCCII (multiple output current controlled current conveyor), a zero-crossing detector (ZCD), and one resistor connected to a fixed potential. The circuit provides the operating frequency up to 10MHz with increased linearity and precision in processing of low-level input voltage signal, with a very low harmonic distortion. The errors related to the signal processing and errors bound were investigated and provided in the paper. The PSpice simulations are depicted and agree well with the theoretical anticipation. The maximum power consumption of the converter is approximately 2.83mW, at ±1.2V supply voltages.
Keywords
Full Text:
PDFReferences
. R. B. Northrop, “Analog Electronics Circuits”, Reading, MA: Addison-Wesley, 1990.
. P. B. Petrović, “A new tunable current-mode peak detector,” Microelectronics Journal, vol. 45, no 6, pp. 805–814, 2014. doi: 10.1016/j.mejo.2014.02.019
. P. B. Petrović, “A New Peak Detector Based on Usage of CCCIIs,” in Proceedings of Advances in Instrumentation and Sensors Interoperability. 19th IMEKO TC 4 Symposium and 17th IWADC Workshop, Barcelona, Spain, 2013.
. A. Fabre, O. Saaid, F. Wiest, C. Bouchheron, “Current controllable bandpass filter based on translinear conveyors,” Electron. Lett., vol. 31, pp. 1727-1728, 1995. doi: 10.1049/el:19951225
. S.J. Gift, “A high-performance full-wave rectifier circuit,” Int. J. Electron., vol. 87, no. 8, pp. 925-930, 2000. doi: 10.1080/002072100404587
. S. Maheshwari, “Current controlled precision rectifier circuits,” Journal of Circuits, Systems, and Computers, vol. 16, no. 1, pp. 129-138, 2007. doi: 10.1142/S0218126607003496
. A.A. Khan, M.A. El-ela, M. A. Al-Turaigi,. “Current-mode precision rectification,” Int. J. Electron., vol. 79, no. 6, pp. 853-859, 1995. doi: 10.1080/00207219508926319
. B. Wilson, V. Mannama, “Current-mode rectifier with improved precision,” Electron. Lett., vol. 31, no. 4, pp. 247-248, 1995. doi: 10.1049/el:19950185
. J. R. Angulo, R. G. Carvajal, J. M. Hereida, A. Torrabla, “Very Low-Voltage Class AB CMOS Precision Voltage and Current Rectifier,” in Proceedings of IEEE Intern. Sym.on Cir.and Sys., pp. III-5III-8, 2000. doi: 10.1109/ISCAS.2000.855981
. A. V. Garcia, R. Venkatasubramanian, J.S. Martinez, E.S. Sinencio, “A Broadband CMOS Amplitude Detector for On-Chip RF Measurements,” IEEE Trans. Instrum. Meas., vol. 57, no. 7, pp. 1470-1477, 2008. doi: 10.1109/TIM.2008.917196
. C. Peters, J. Handwerker, D. Maurath, Y. Manoli, “A Sub-500 mV Highly Efficient Active Rectifier for Energy Harvesting Applications,” IEEE Trans. Cir. Sys.-I, vol. 58, no. 7, pp. 1542-1550, 2011. doi: 10.1109/TCSI.2011.2157739
. E. Yuce, S. Minaei, O. Çicekoglu, “Full-wave rectifier realization using only two CCII+s and NMOS transistors,” Int. J. Electron., vol. 93, no. 8, pp. 533–541, 2006. doi: 10.1080/00207210600711606
. S. Minaei, E. Yuce, “A new full-wave rectifier circuit employing single dual-X current conveyor,” Int. J. Electron., vol. 95, no. 8, pp. 777–784, 2008. doi: 10.1080/00207210802141826
. C. Toumayou, F. J. Lidgey, S. Chattong, “High frequency current conveyor precision full-wave rectifier,” Electron. Lett., vol. 30, no. 10, pp. 745–746, 1994. doi: 10.1049/el:19940539
. J. Koton, N. Herencsar, K. Vrba, “Minimal configuration precision full-wave rectifier using current and voltage conveyors,” IEICE Electron. Express, no. 7–12, pp. 844–849, 2010. doi:10.1587/elex.7.844
. J. Koton, N. Herencsar, K. Vrba, “Current and voltage conveyors in current and voltage-mode precision full-wave rectifiers,” Radioengineering, vol. 20, no. 1, pp. 19–24, 2011.
. J. Koton, N. Herencsar, K. Vrba, S. Minaei, “Precision full-wave current-mode rectifier using current differencing transconductance amplifier,” in Proc. of 2011 Int. Conf. on Computer and Communication Devices (ICCCD 2011), Bali Island, Indonesia, pp. 71–74, 2011. doi: 10.1109/ICCSN.2011.6014935
. S. Hashemi M. Sawan, Y. Savaria, “A novel low-drop CMOS active rectifier for RF-powered devices: experimental results,” Microelectron. Journal, vol. 40, no. 11, pp. 1547–1554, 2009. doi: 10.1016/j.mejo.2009.02.007
. M. Kumngern, “CMOS current-mode precision full-wave rectifier with improved bandwidth,” Second Int. Conf. on Digital Information and Communication Technology and its Applications (DICTAP), pp. 283–286, 2012. doi: 10.1109/DICTAP.2012.6215357
. F. Khateb J. Vavra, D. Biolek, “A novel current-mode full-wave rectifier based on one CDTA and two diodes,” Radioengineering, vol. 19, no. 3, pp. 437–445, 2010.
. J. Koton, N. Herencsar, K. Vrba, “Current-mode precision full-wave rectifier using single DXCCII and two diodes,” 20th European Conf. Circuit Theory and Design (ECCTD), pp. 508–511, 2011. doi: 10.1109/ECCTD.2011.6043400
. N. Pandey, R. Pandey, “Current mode full-wave rectifier based on a single MZC-CDTA,” Act. Passiv. Electron. Compon., Article ID 967057, pp. 1–5, 2013. doi: 10.1155/2013/967057
. W. Tangsrirat, “Current-tunable current-mode multifunction filter based on dual-output current-controlled conveyors,” AEÜ-Int. J. Electron. Commun., vol. 61, no. 8, pp. 528–533, 2007. doi: 10.1016/j.aeue.2006.09.005
. Evaluation of measurement data — Supplement 1 to the “Guide to the expression of uncertainty in measurement” - Propagation of distributions using a Monte Carlo method, BIPM, 2008.
. D. R. Frey, “Log-domain filtering: an approach to current mode filtering,” IEE Proc Circuit Devices Syst., vol. 140, pp. 406–416, 1993. doi: 10.1049/ip-g-2.1993.0066
. AH5010/AH5011/AH5012 Monolithic Analog Current Switches, National Semiconductor, data sheet, 1995.
. P.P. Sahu, M. Singh, A. Baishya, “A Novel Versatile Precision Full-Wave Rectifier,” IEEE Trans. Instrum. Meas., vol. 59, no. 10, pp. 2742-2746, 2010. doi: 10.1109/TIM.2010.2045539
. K. Anuntahirunrat, W. Tangsrirat, V. Riewruja, W. Surakampontor, “Sinusoidal frequency doubler and full-wave rectifier using translinear current controlled conveyors,” Int. J. Electronics, vol. 91, no. 4, pp. 227–239, 2004. doi: 10.1080/00207210410001690656
. M. Sagbas, S. Minaei, U. E. Ayten, “Component reduced current-mode full-wave rectifier circuits using single active component,” IET Circuits, Devices&Systems, vol. 10, no. 1, pp. 1–11, 2016. doi: 10.1049/iet-cds.2013.0461
. D. Biolek, E. Hancioglu, A.U. Keskin, “High-performance current differencing transconductance amplifier and its application in precision current-mode rectification,” AEÜ-Int. J. Electron. Commun., vol. 62, no. 2, pp. 92–96, 2008. doi: 10.1016/j.aeue.2007.03.003
. J. Koton, K. Vrba, N. Herencsar, “Fast voltage-mode full-wave rectifier using CCII and DXCCII,” Eighth Int. Conf. on Electrical and Electronics Engineering (ELECO 2013), Bursa, Turkey, pp. 49–52, 2013. doi: 10.1109/ELECO.2013.6713934
. M. Kumngern, “New versatile precision rectifier,” IET Circuits Devices&Systems, vol. 8, no. 2, pp. 141–151, 2014. doi: 10.1049/iet-cds.2013.0232
. A. Monpapassorn, “Low output impedance dual CCII full-wave rectifier,” Int. J. Electron., vol. 100, no. 5, pp.648–654, 2013. doi: 10.1080/00207217.2012.720943
Refbacks
- There are currently no refbacks.
Copyright (c) 2017 Informacije MIDEM