A New Low-Power CMOS Sample-and-Hold Circuit Based on High-Speed Dynamic Body Biased Switches

Mohammad Hasan-Sagha, Mohsen Jalali

Abstract


In this paper, a low-power open-loop CMOS sample-and-hold (S/H) circuit with improved linearity is presented. The incorporated switches utilize dynamic body connection technique to reduce distortions due to threshold voltage variations during track mode as well as signal feedthrough in the hold mode. To accomplish dual-edge sampling characteristic and differential operation, the proposed S/H circuit utilizes two pairs of the proposed switch and a 2:1 multiplexer. A current mode logic multiplexer without tail current is utilized to reduce power consumption while still fulfilling the speed and linearity requirements. The proposed S/H circuit is designed in a 90-nm CMOS process where it consumes approximately 610 μW from a 1.2 V supply voltage. A SFDR of about 73 dB is achieved when sampling a 1 GHz differential sinusoidal input at 2 GS/s rate using both edges of a 1 GHz clock signal.

Keywords


Sample and hold circuits; high-speed switches; body biasing; dual-edge sampling.

Full Text:

PDF

References


R. Bagheri et al., "An 800-MHz–6-GHz Software-Defined Wireless Receiver in 90-nm CMOS," in IEEE Journal of Solid-State Circuits, vol. 41, no. 12, pp. 2860-2876, Dec. 2006.

M. Motoyosh, T. Koizum, T. Maehata, S. Kameda and N. Suematsu, "High SNR CMOS S/H IC for multi-carrier direct RF under sampling receiver," 2016 IEEE International Symposium on Radio-Frequency Integration Technology (RFIT), Taipei, 2016, pp. 1-3.

J. Cheng, N. Qi, P. Y. Chiang and A. Natarajan, "A Low-Power, Low-Voltage WBAN-Compatible Sub-Sampling PSK Receiver in 65 nm CMOS," in IEEE Journal of Solid-State Circuits, vol. 49, no. 12, pp. 3018-3030, Dec. 2014.

T. Koizumi et al., "A CMOS series/shunt switching type S/H IC for Ka-band direct RF under sampling receiver," Asia-Pacific Microwave Conference (APMC), Nanjing, 2015, pp. 1-3.

T. S. Lee, C. C. Lu, S. H. Yu, and J. T. Zha, A very-high-speed low-power low-voltage fully-differential CMOS sample-and-hold circuit with low hold pedestal, Proc. IEEE Int. Symp. Circuits and Systems (ISCAS) (2005), pp. 3111-3114.

M. Mousazadeh, K Hadidi, and A. Khoei, A novel open-loop high-speed CMOS sample-and-hold. AEU-Int. Journal of Electronics and Communications. 62 (2008) 588-96.

K. D. Sadeghipour, A new passive sample and hold structure for high-speed, high-resolution ADCs. AEU-Int. Journal of Electronics and Communications. 65 (2011) 799-805.

A. Shirazi, S. Mirhaj, S. Ashtiani, and O. Shoaei, Linearity improvement of open-loop NMOS source-follower sample and hold circuits, IET Circuits, Devices & Systems. 5 (2011) 1-7.

M. Hasan-Sagha, and M. Jalali, Very high speed and low voltage open-loop dual edge triggered sample and hold circuit in 0.18 µm CMOS technology, Proc. IEEE Int. Conf. Semiconductor Electronics (ICSE) (2012), pp. 645-648.

A. Boni, A. Pierazzi, and C. Morandi, A 10-b 185-MS/s track-and-hold in 0.35 µm CMOS, IEEE J. Solid State Circuits. 36 (2001) 195-203.

D. Jakonis, and C. Svensson, A 1GHz linearized CMOS track-and-hold circuit. Proc. IEEE Int. Symp. Circuits and Systems (ISCAS) (2002) pp. 1265-1277.

B. Razavi, Design of Analog CMOS Integrated Circuits (McGraw-Hill, New York, 2016).

C. J. B. Fayomi, G. W. Roberts and M Sawan, Low voltage CMOS analog bootstrapped switch for sample-and-hold circuit: design and chip characterization, Proc. IEEE Int. Symp. Circuits and Systems (ISCAS) (2005) pp. 2200-2203.

K. Ohhata, K. Yayama, Y. Shimizu and K. Yamashita, A 1-GHz, 56.3-dB SFDR CMOS track-and-hold circuit with body-bias control circuit, Journal of IEICE Electronics Express. 4 (2007) 701-706.

G. Huang and P. lin, A fast bootstrapped switch for high-speed high-resolution A/D converter, Proc. IEEE Asia Pacific Conf. Circuits and Systems (2010) pp. 382-385.

K. Ohhata, K. Yayam, Y. Shimizu and K. Yamashita, A 1-GHz, 56.3-dB SFDR CMOS track-and-hold circuit with body-bias control circuit, Journal of IEICE Electronics Express 4 (2007) 701-706.

H. Movahedian, B. Sedighi and M. S. Bakhtiar, Wide-range single-ended CMOS track-and-hold circuit, Journal of IEICE Electronics Express 4 (2007) 400-405


Refbacks

  • There are currently no refbacks.


Copyright (c) 2017 Informacije MIDEM